K10,K20,K30 carbide gripper inserts for chuck jaws
Tungsten Carbide Gripper Jaw Inserts Usage:
It is used for gripping drill rods used in diamond drilling industry.Such as: diamond drilling, coal mining, stone mining and oil mining.
Tungsten Carbide Jaw Gripper Process Introduction:
1. High purity of raw material, less impurity content, more stable physical properties of plate.
2. Spray drying technology is adopted to protect the material with high purity nitrogen under the condition of full sealing, which effectively reduces the possibility of increasing oxygen in the preparation process of the mixture, has better purity, and the material is not easy to dirty.
3. Uniform density: 300Mpa isostatic press is used to suppress, which effectively avoids the generation of pressing defects and makes the blank density more uniform.
4. The plate has good density, good strength and hardness indexes: ship low-pressure sintering technology is adopted to
effectively reduce the pores in the plate and stabilize the quality.
Popular sizes for tungsten carbide jaw gripper：
| 35×6×4 | 28×6×5.5 | 22×10×6.3 | 25×3×5 | 35×6×4 |
| 30×7×7 | 30×6×6 | 28×8×7 | 15×6.8×7 | 22×10×6 |
| Note：Other sizes and customized sizes is also available for us. | ||||
Tungsten Carbide gripper inserts are used in different ways, such as diamond drilling, coal mining, stone mining and oil mining.
Carbide Inserts for Hydraulic and Mechanical chucks
Tungsten Carbide Gripper Insert Gripper Teeth
Carbide gripper inserts are our featured products for worldwide markets.
Steady performance, long service time and used in different ways for mining field.
Like coal mining, stone mining and oil mining.
content is empty!